GW Instek APS-1102 Control Software User Manual - Manual (Page 19)

2.2 Installation Procedure
2-3
2.2 Installation Procedure
When installing or uninstalling the software in a Windows 2000 or XP environment, log on as a
user who has an administrator privilege with a user name comprising 1-byte characters.
2.2.1 Installing the USB driver software
The USB driver software can be downloaded from the National Instruments Corporation website.
The procedures for installing the USB driver software are described below.
1. Search for the VISA Run-time Engine page on the National Instruments Corporation website or
select “VISA driver downloads” at the following URL.
http://www.ni.com/support/visa/
2. Download VISA Run-time Engine from the VISA Run-time Engine page.
User registration must be performed at this time. Download VISA Run-time Engine Ver. 3.3 or
later.
3. The downloaded file is a self-extracting file. Extract it and install the software.
4. The USB driver software is installed when installation is successfully complete.
For details, visit the National Instruments Corporation website.
After installing the USB driver software, connect the device to the PC as follows:
a) Make sure that the device and the PC are not connected.
b) Power-on the device and connect the device and the PC using a USB cable.
c) The installation process starts automatically. Follow the guidance.