GW Instek APS-1102 Control Software User Manual - Manual (Page 31)

4.5 Operations for Each Unit
4-7
The limiters or range limit values under the miscellaneous settings can only be set to the device
through the “RMT Remote Control Software”. Input checking for items corresponding to the
“oscillator settings” is not performed.
Like the “oscillator settings”, the setting range for the numerical setting input item is also displayed
under the miscellaneous settings.
However, even if the value is within the displayed setting range, it may not be possible to set the
value to the items related to the device setting range limit to the device, depending on the device
status.
See the device manual for details on the device setting range limit.
4.5.4 Output setting
To set output, click the ON or OFF button.
The setting device status is displayed next to the OK button. “OUTPUT” is displayed in bright
yellow at the ON status.
Off status
On status
Figure 4-10 Output Setting
It may not be possible to turn output on, depending on the device status. In such a case, an error
occurs.
The device is querried for the output status about every two seconds and the result is reflected on the
screen.
！
Caution