beautypg.com

1 contraction/extension of horizontal axis – GW Instek APS-1102 Control Software User Manual User Manual

Page 76

background image

APS-1102 Control Software User Manual

8-12

8.2.1

Contraction/extension of horizontal axis

Select the range with the markers on the waveform display screen before contracting/extending the
horizontal axis.

“7.5.6 Range selection”

Contraction/extension of the horizontal axis can be set in the contraction/extension screen [X axis]
area.

a) Using the selected range as the contraction/extension start/end points

Input numerical values in the input areas to the right of [Start Point X=] and [End Point X=]
and click the

OK

button.

The range selected with the markers in advance can be contracted, extended, or moved to the
range selected with the start/end points.
Data immediately before or after is filled in the area where data is removed as a result of
contraction/extension.

b) Extending the selected range to the full size

Click the

Fit Length button to extend the range selected with the markers in advance to the

whole waveform.
Most of actual data collected with the digital oscilloscope does not exactly consist of one cycle.
In such a case, this function can clip one cycle.

c) Miscellaneous

Note that the waveform may be distorted when the contraction/extension rate is too high.