GW Instek APS-1102 Control Software User Manual - Manual (Page 117)

11.2 Offline Mode
11-3
11.2 Offline Mode
This software checks whether a device is connected at every startup. If the software cannot find
the connected device, a message appears to confirm that the software is to start up in the offline
mode.
See “Figure 9-1”.
In the offline mode, the software operates only in the “edit mode”. It is not impossible to change the
mode to “execution mode”.
11.3 Changes Between the Edit and Execution Modes
Edit mode and execution mode switched in two ways.
 Select [Edit mode] or [Execution mode] from the [Mode] menu.
 Click the Change mode button.
When switching from the Edit mode to the Execution mode, the software transfers the created
sequence data to the device. The progress of transfer is displayed with the progress bar appearing
in the center of the window.
Although the functions related to sequence execution can be executed in the execution mode,
functions related to edit cannot be executed.
！ Caution
！ Caution