GW Instek APS-1102 Control Software User Manual - Manual (Page 20)

APS-1102 Control Software Manual
2-4
2.2.2 Installing the APS-1102 CONTROL SOFTWARE
(a) Insert the APS-1102 Control SoftwareCD-ROM into the CD-ROM drive of the PC.
(b) Execute
[Setup.EXE] on the CD-ROM or [D:\Setup.EXE] from [Run] on the start menu.
[D:] indicates the CD-ROM drive. If another drive letter is assigned to the CD-ROM driver,
assign it appropriately, according to your system.
(c) Click
the Next button, following the screen guidance to start installation.
(d) When installation has been completed, the “APS-1102 Control Software” can be executed.
Click
[APS-1102] from Start - [Programs] - [APSTool] - [APS1102] to execute the
software.
2.2.3 Uninstalling the APS-1102 CONTROL SOFTWARE
To remove the APS-1102 Control Software, first double-click [Add/Remove Programs] from the
control panel. Next, click the [APS-1102 Control Software] and the Change/Remove button.
Note that the folder in which the APS-1102 Control Software was installed may not be removed
in some cases. All the files created in the folder remain as they are. If the folder is unnecessary,
delete it after uninstallation.