beautypg.com

3 operation execution – GW Instek APS-1102 Control Software User Manual User Manual

Page 82

background image

APS-1102 Control Software User Manual

8-18

b) Clipboard

Clicking the

Clip Board

button or pressing

Alt

+

B

displays the waveform stored on the clipboard

in the [Clip Board/Created Waveform] area. Clipboard:

“7.7.2 Clipboard”

If the selected range is longer than the clipboard, the overflowing part of the waveform is treated as
zero data.
If the clipboard is longer than the selected range, the first part of the clipboard is used.
Though data on the clipboard are in 16-bit integers (

32768 to +32767), they are converted into the

vertical axis unit in the inter-waveform operation. For example, when the vertical axis user unit is

1

to +1, ±32767 on the clipboard is treated as ±1.

8.4.3 Operation

execution

Clicking the

=

button displays the result of inter-waveform operation in [Operation Result].

Click the

OK

button to return to the waveform display screen and reflect the operation result.

Click the

Cancel

button or press the

Esc

key to return to the waveform display screen without

performing any operation.

It is recommended to set the vertical axis unit to the user unit:

1 to +1, especially when executing

multiplication in inter-waveform operation.
Under this setting, the result of multiplying ± full scale values can be a ± full scale value.
When the operation result exceeds the ± full scale scale value, waveforms are clipped at the ± full
scale value.

Note that dividing a number by 0 results in infinity and an error usually occurs. To avoid such an
error, the result of division by 0 is 0 as an exception in this inter-waveform operation.