GW Instek APS-1102 Control Software User Manual - Manual (Page 94)

APS-1102 Control Software User Manual
9-4
9.3 Start and Termination
For how to start the SEQ Sequence Edit Software, see “3.2 Starting the Subsoftware”.
The message in the following figure appears when the software is started for the first time or when
the previously set device is not connected.
Figure 9-1 Message Displayed When Sequence Edit Software Is Started
When Yes(Y) is clicked the software is started in the offline mode. When No(N) is clicked, the
software is not started.
After starting the software, connect the device and make system settings.
“11.7 System Settings”
If the above operations are not performed, the device remains in the offline status.
The software is exited when [File(F)] - [Exit(X)] is selected or the Close button is clicked.
The system setting dialog box appears only when the software is started for the first time. For
details,
see “11.7 System Settings” .
！ Caution