GW Instek APS-1102 Control Software User Manual - Manual (Page 83)

8.5 Transferring the Waveform and Settings
8-19
8.5 Transferring the Waveform and Settings
The system setting screen is used to set the device model, interface, and main parameters.
This screen is also used to transfer the signal generator settings or waveform data to the device.
In addition, the vertical/horizontal axis unit displayed on the waveform display screen can be set on
this screen.
Select [Setup] - [System Setup] (
Alt , S , S ) to open the system setting screen.
Figure 8-6 System Setup Screen
The system setting screen consists of two “tab pages”: [System Setup] and [Unit Setup].
Click the [System Setup] tab or press
Alt + S to activate the [System Setup] page.
Click the [Unit Setup] tab or press Alt + U to activate the [Unit Setup] page.