GW Instek APS-1102 Control Software User Manual - Manual (Page 100)

APS-1102 Control Software User Manual
9-10
Branch steps can be set respectively for step numbers.
In the common parameters or sequence execution parameters setting area, select the cell of the step
number, and then enter the step number for each branch channel.
Clicking the Branch button or entering the sequence branch trigger during execution of the
sequence can change the sequence to the appropriate step number.
If the step number of the branch channel is 0, no sequence transition will take place.
Step number in the branch step setup area shows the
step number of the currently selected cell.
Figure 9-7 Setting the Branch Steps