GW Instek APS-1102 Control Software User Manual - Manual (Page 132)

APS-1102 Control Software User Manual
13-2
13.1 Handling CD-ROM
Handle the CD-ROM carefully as described below.
 Store the CD-ROM in a place without direct sunlight, high temperature, and high humidity.
 Use and store the CD-ROM in a place without dust.
 Do not touch the recording surface directly. It may cause damage or errors.
 If it is dirty, wipe it with a soft dry cloth. Do not use any solvent such as benzene.
 Store the CD-ROM in a vertical or horizontal position so that it would not be deformed.
 When writing on the label surface of the CD-ROM, use a felt-tipped pen (Do not use anything
with a hard point such as a ball point pen or pencil.)
13.2 Replacement of Damaged CD-ROM
If the APS-1102 Control SoftwareCD-ROM is damaged, contact Good Will or your local
distributor.
13.3 Version Check
The version can be displayed by selecting [Help] - [Version]. The following shows a version
display dialog box example for [RMT].
Figure 13-1 Version Dialog Box