GW Instek APS-1102 Control Software User Manual - Manual (Page 127)

12.2 Remote Control Software Errors
12-3
12.2 Remote Control Software Errors
The following table summarizes the error specifications of the RMT Remote Control Software.
Table 12-2 RMT Error Messages
Message Description
The device hasnot been connected.
The device set by the conditions cannot be communicated
with at start or system setting modification.
Can’t communicate with the device.
The device can no longer be communicated in the online
status. The offline status is set.
Invalid file format.
The software is exited displaying the error message because
the necessary file cannot be found in this software or is
illegal at startup.
The sequence execution was stopped.
The sequence is stopped because the sequence of the device
for which conditions are set is in progress at startup or when
system setting is changed.
The device settings in the read device setting
file contain an error.
An error occurred when the specified device setting file was
read and set to the device. If an error persists even if the
device setting file is read again by selecting [Memory] -
[Rest], do not use the device setting file.
Can’t change the setting while logging.
A measurement value display that cannot be set during
logging operation was set. To change the setting, stop
logging once and change the setting. Reinstall the software.
Insufficient disk space.
Logging is stopped, displaying an error message due to
insufficient disk space to which the logging data file is saved.
Writing error.
Logging is stopped, displaying an error message if an error
occurred while data is written into the logging data file.
Invalid value for logging interval.
Set a logging condition, having a logging interval with a
value between 1 and 60 seconds.
Designate the folder to save. Specify a logging condition, saving the folder name.
Logging quitted for the maximum logging
points.
Logging is stopped because 86,400 items have been logged
since logging was started.