GW Instek APS-1102 Control Software User Manual - Manual (Page 3)

i
Preface
Thank you for purchasing the APS-1102 Programmable AC/DC Power Source.
To ensure safe use of this product, please first read Safety Precautions on the following pages.
 Before Reading This Manual
This manual is a PDF file stored in the CD-ROM (filename: APS-1102 Control Software
Manual.pdf which comes with the APS1102 Programmable AC/DC Power Source). Acrobat Reader
(Adobe Systems, Inc.) Ver. 9 or higher is required to view the file contents.
This manual is intended for users with knowledge for basic operation of the operating system (OS)
(Microsoft Windows 2000/XP) to be used. For basic operation of the Windows OS or definitions of
terms such as “click” and “drag”, see the user’s guide of the Windows OS.
Figures or messages shown in this manual are for the Windows 2000 environment, and may
differ in other environments.
 Caution Symbols Used in This Manual
The following caution symbols are used in this manual. Be sure to observe these caution symbols
and their contents.
This mark indicates cautions on handling of this program.
 This manual has the following chapter organization.
If you are reading this manual for the first time, start from 1. OVERVIEW
1. OVERVIEW
Presents brief descriptions of the Remote Control Software functions.
2. INSTALLATION and 3. LAUNCHER
Describes environmental requirements for operation of the Remote Control Software as well
as its installation and startup procedures.
4. REMOTE CONTROL and 5. LOGING
Describes the operation procedures for remote control and logging.
6. OVERVIEW OF ARBITRARY WAVEFORM CREATION to 8. ARBITRARY WAVEFORM 
OTHER SCREEN OPERATIONS
Describes the operation procedures for creating an arbitrary waveform.
9. SEQUENCE EDITING to 11. OTHER SCREEN OPERATIONS FOR SEQUENCE EDITING
Describes sequence editing.
12. ERROR MESSAGES
Describes error specifications.
13. MAINTENANCE
Describes management of the CD-ROM and actions to take when the device is damaged.
CAUTION