GW Instek APS-1102 Control Software User Manual - Manual (Page 103)

9.6 Sequence Control Buttons
9-13
<4> [Stop] button
This button is used to stop the sequence. The output when the sequence is stopped is held.
After this button has been pressed, the Stop, Hold, and Branch button will be unavailable.
Clicking the Start button in this state can restart the sequence, beginning at step 1.
<5> [Hold] button
This button is used to stop the sequence temporarily. The output when the sequence is paused
is held.
Clicking the Start button can resume the sequence from a step that has temporally stopped.
Click the Stop button to terminate the sequence.
<6> [Branch] button
This button is used to branch the sequence. Clicking the Branch button with a branch
channel number entered into the [Branch Channel] field moves the sequence to the step
currently set in the branch step.