GW Instek APS-1102 Control Software User Manual - Manual (Page 46)

APS-1102 Control Software User Manual
6-4
6.4 Copying and Pasting a Waveform
This section explains how to create a full-wave rectification waveform, as a sample of copying and
pasting waveforms.
Step 1: Click the button to the top left of the screen. The same result can be obtained when
[Tools] - [Waveform Create] is selected.
Step 2: The sine wave is selected in the initial status, so click the All Page OK button
without changing it and return to the waveform display screen.
Step 3: Move marker B to the center of waveform.
When the memory size is 4 KW, [4096.000Word] is displayed to the bottom right of
the screen.
Set [2048], which is the half of the memory size, in the number area to the right of
[MrkB(X)] and press the Enter
key.
Step 4: Press the C key while holding down the Ctrl key. The same result can be obtained
when [Edit] - [Copy] is selected. The area between markers A and B, that is, the first
half data of waveform is copied to the clipboard.
Step 5: Click (option button) to the left of [ Interlock (R)], making it (selected
status) to set the interlock mode to the marker.
Set [2048] in the number area to the right of [MrkA(X)] and press the Enter
key.
Step 6: Press the V key while holding down the Ctrl key. The same result can be obtained
when [Edit] - [Paste] is selected.
The waveform data on the clipboard is pasted to the latter half of waveform.
Explanation 1: If the signal generator model is changed and the memory size is no longer 4 KW,
2048 in steps 3 and 5 must be changed to the half of each memory size.
Explanation 2: The operation of pressing the C key while holding down the Ctrl key is hereinafter
expressed as Ctrl + C .
Ctrl + C (Copy) leaves the waveform in the copied area as is.
Ctrl + X (Cut) is the same in that the data in the selected area is saved onto the
clipboard. The waveform in the selected area is deleted, however.
Ctrl + D (Delete) deletes the waveform in the selected area but the data on the
clipboard does not change.
Explanation 3: Use markers A and B to select the range.
For example, when the range specified with the markers is from 0 to 2048, the actual
selection range will be 0
 X < 2048.
Explanation 4: For the clipboard, see “7.7.2 Clipboard” and your Windows OS manual.