GW Instek APS-1102 Control Software User Manual - Manual (Page 97)

9.4 Sequence Edit Area
9-7
9.4.2 Setting parameters
You can set each parameter by inputting the desired value directly into the selected cell. The input
values are checked for range appropriateness.
Selecting [Edit] - [Initialize] or pressing Ctrl + I can return the selected set values to the
defaults.
To set a value in [Step termination], [Waveform], [Sync Out], or [Unit], click the desired cell
and select the value from the combo box as shown in “Figure 9-4 Combo Boxes”.
Figure 9-4 Combo Boxes
 Set [Stop] as the terminal for the last step.
 Though a jump number can be set for the step of which “Step termination” is set to Stop, the
setting is ignored if Stop is set for “Step termination” and the jump number is valid in other cases
(when Stop is set, jump is not executed).
 Jump number 0 indicates that transition to the next step number will take place without jumping.
 Jump count 0 indicates that the jump will repeat infinitely.
 For parameter details, see the APS-1102 User Manual.
Note that different terms are used for the same meanings in this software’s manual and the
APS-1102 User Manual.
[This software] [APS-1102 Programmable AC/DC Power Source]
End phase Step end phase
Terminal Step terminal
Synchronous output Step synchronous output
Constant CONST
Retain KEEP
Sweep SWEEP
Continue Continue the sequence
Exit Move to the Idle status
Hold Move to the Hold status
Jump number Jump step
！ Caution