GW Instek APS-1102 Control Software User Manual - Manual (Page 56)

APS-1102 Control Software User Manual
7-4
7.2 Tool Menu
The tool menu options are shown below.
Opens the waveform create screen, as does the button on the toolbar.
Opens the compress/decompress screen, as does the button on the toolbar.
Opens the interpolate screen, as does the button on the toolbar.
Opens the operate screen, as does the button on the toolbar.
For example, pressing Alt, T , C opens the waveform generation screen.
Waveform create screen See “8.1 Generation of Standard Waveform and
Numerical Expression Waveform”.
Compress/decompress screen See “8.2 Contraction/Extension”.
Interpolate screen See “8.3 Waveform Generation Through
Interpolation”.
Operate screen See “8.4 Operation Between Waveform”.
7.3 Setting Menu
The setting menu options are shown below.
Opens the system setup screen.
Turns on/off the grid display in the waveform display area.
Selecting [Setup] - [Setup] ( Alt , S , S ) opens the system setup screen.
On the system setup screen, it is possible to select the signal generator model, set or transfer main
parameters, transfer waveform data, set the display unit, or perform other operations.
See “8.5 Transferring the Waveform and Settings”.
Each time [Setup] - [Show Grid] ( Alt , S , G ) is selected, the grid display in the waveform
display area is turned on or off.
No grid is printed out when a waveform is printed out.
See “7.6.6 Print”.
7.4 Undo and Redo
In the “ARB” it is possible to revert the waveform creation or editing operation to the previous status
(Undo). Select [Edit] - [Undo] ( Alt , E , U ) or pressing Ctrl + U undoes the operation.
To cancel the Undo operation (Redo), select [Edit] - [Redo] ( Alt , E , R ) or press Ctrl + U .