GW Instek APS-1102 Control Software User Manual - Manual (Page 128)

APS-1102 Control Software User Manual
12-4
12.3 Arbitrary Wave Edit Software Error
The following table summarizes the error specifications of the ARB Arbitrary Waveform Editor.
Table 12-3 ARB Error Messages
Message Description
Memory Allocation Failed. Memory for OS operation could not be secured at startup.
No Spline point.
During waveform generation using interpolation, the
interpolation was performed without any control points
specified.
Cannot create two spline point on same X.
Do you want continue?
Displayed when the leftmost and rightmost values of the Y
axis are different when generating a waveform using
interpolation.
File Write error.
An error occurred while a file was being saved in ARB. If
this error persists, restart the ARB.
File Read error
An error occurred while a file was being read in the ARB. Do
not use this file.
Clip Board Open error.
An error occurred during an inter-waveform operation
executed for the clipboard. If this error persists, restart the
ARB.
Clip Board Read error.
Clip Board Write error.
Clip Board error.
Constant format error.
An arbitrary function expression for waveform generation
contains an error.
Modify the error cause according to the message.
Syntax error in equation.
Lack of parenthesis.
Unblance of parenthesis.
Divided by 0.
Compile error.
Illegal Font Size. Modify the specified font size in the printing dialog box.
No Listeners on the ITERFACE.
Communication with the device failed. Check the
connection between the device and PC.