3 signal generator setting – GW Instek APS-1102 Control Software User Manual User Manual
Page 85
8.5 Transferring the Waveform and Settings
8-21
c) Waveform memory number
Click the button to the right of [Memory Number] to select a waveform memory number.
Click to increase the memory number and click to decrease the memory number.
It is also possible to directly input a numerical value in the numerical value display area.
8.5.3
Signal generator setting
The [Power Setup] frame in the [System Setup] page is used to set the device mode, output
on/off, frequency (cycle), output range, amplitude, and DC offset.
The relationship between the signal generator models and settable items is shown in “Table 8-5
Device Setting Item”.
Table 8-5 Device Setting Items
APS-1102
Mode
(AC-INT, AC-ADD, ACDC-INT, ACDC-ADD only)
Output on/off
Frequency
Cycle
Output range
Amplitude
DC offset
(ACDC-INT, ACDC-ADD only)
In the frequency, cycle, amplitude, and DC offset, T (10
+12
), G (10
+9
), M (10
+6
), k (10
+3
), m (10
-3
),
u (10
-6
:
), n (10
-9
), p (10
-12
), f (10
-15
), and a (10
-18
) can be added after the number.
The power setting is initialized after the next startup after ARB is exited or an additional ARB is
started.
a) Mode
Click the
button to the right of [Mode (M)] to display the list of selectable modes.
Click one in the list or press the
keys to select a mode.
b) Output on/off
Click (option button) to the left in the [ ON] or [ OFF] display in the [Output on/off]
section to make it selected ( ), to select on or off.
c) Frequency
Click the input area to the right of [Frequency] or press
Alt
+
Q
to activate the input area. Input
a numerical value in this status and press the
Enter
key to determine the value.
Changing the frequency setting also updates the cycle (inverse number of frequency) display.
If the frequency currently set exceeds the actual upper limit of an arbitrary waveform, a warning
message appears.
The actual upper limit of an arbitrary waveform and the settable range of the frequency differ