GW Instek APS-1102 Control Software User Manual - Manual (Page 41)

5.6 Logging Conditions
5-5
5.6 Logging Conditions
Select [Setting(S)] - [Logging Condition] to display the [Logging Condition] dialog box.
Figure 5-4 Logging Condition Dialog Box
Save in File When this check box is selected, currently logged data is saved to a file.
Save Folder Specify the folder to which logging data is saved.
To specify the destination folder, click the button to display the
[Specify Folder] dialog box where the destination folder can be
specified.
Logging Interval Specify the logging interval between 1 and 60 seconds.
When the OK button is clicked, setting conditions are checked. If no error is detected, the setting
conditions are saved and the dialog box is closed. Saved conditions are used for logging next time
the software is started.
Clicking the Cancel button closes the dialog box without saving setting conditions.
Setting conditions cannot be changed during logging.
The logging interval does not guarantee logging operation at the specified intervals.
5.7 Logging Data File
The logging data file saved at logging is saved under the following conditions:
File name The file is named as YYYYMMDD_HH_MM_SS.txt using the logging
start time information (extension: txt)
File format
First row Measurement item (separated with commas)
Second and subsequent rows Time information, logging data, ... (separated with
commas).
For logging data, see the next section.
！ Caution