Spectra Precision Survey Pro v3.80 Recon iPAQ Reference Manual - Manual (Page 89)

Survey Menu
R-83
Traverse Now or Later? Dialog Box
After taking a shot with the 7UDYHUVH button, the
Traverse Now or Later? dialog box will open where you
can specify if you want to traverse now or later .
7UDYHUVH 1RZ : expects you to move your total station to
the next occupy point before any additional shots are
taken. The occupy, foresight, and backsight points will
be updated accordingly.
7UDYHUVH /DWHU : allows you to take additional side shots
before moving the total station to the next traverse point.
This is useful is you want to take side shots from the
current occupy point, but perform the traverse shot as
the first shot of the current set up to ensure the highest
accuracy.
When you have finished taking side shots, tap the
7UDYHUVH button again. You can then select 7UDYHUVH 1RZ and set
up on the next occupy point, or select 6KRRW 1HZ 7UDYHUVH to re-shoot
the traverse shot.
New Occupy Point Dialog Box
After traversing to a new point, the New Occupy Point
dialog box will open that informs you of the points that
have been updated and computes the azimuth to the new
backsight.
New Backsight Circle : displays the horizontal angle that
should be displayed on the total station once it is set up
over the
New Occupy Point and facing the New Backsight
Point . This angle is typically zero unless you are
surveying in true azimuths, as set in the Surveying
Settings screen (Page R-34).
Height of Instrument : is the new height that the total
station is above the ground.