Spectra Precision Survey Pro v3.80 Recon iPAQ Reference Manual - Manual (Page 41)

Job Menu
R-35
has been configured while in GPS Mode. This button will compute a
scale factor based on the current map projection.
;
Prompt to Reset Scale on New Setups : if checked when a map
projection is selected and you set up over a new location, the specified
scale factor is compared to the scale factor defined for your current
location in the mapping plane. If the scale factor is different, you will
be prompted to use the new scale factor.
Stakeout Settings
The Stakeout Settings card contains the setting that control how
stakeout is performed.
; Stake “Corners,” Not Just Even Intervals : when
staking by stations, locations where a line segment
changes, such as from a straight section to a curve, will
also be staked when this is checked.
;
Always Start Stakeout With Coarse Mode : When
checked, the Coarse EDM (fast shot) checkbox found in all
stakeout screens will initially be checked. This instructs
the total station to measure distances faster, but with
slightly less accuracy.
;
Use Manual Updating (Remote Control) : When this is
checked, a 6KRW button in the stakeout screens must be
pressed to take a shot. When this not checked, shots are
continuously taken in the stakeout screens. (This is only
valid when running in remote mode, using a robotic total
station.)
;
Design Elevation from Offset Segment : When checked during
offset or road stakeout, cut and fill information will be computed from
the design elevation at the node furthest from the centerline of the
current segment. When unchecked, cut and fill information will be