Spectra Precision Survey Pro v3.80 Recon iPAQ Reference Manual - Manual (Page 131)

Stakeout Menu
R-125
%DFN : returns to the previous screen.
1H[W ! : accesses the next screen.
Offset Staking – Screen Three
The third Offset Staking screen is used to select the station and
section of the road to be staked and to specify an offset distance from
the design point.
Station to Stake : is the station to be staked.
Station Interval : specifies how far to advance from the current station
to the next station.
1H[W 6WD : advances the current station by the Station
Interval .
Note: When advancing, if you want to also stake the
locations where the alignment of the road changes, be
sure to check the
Stake “Corners”, Not Just Even Intervals
option in the Stakeout Settings card. Tapping the
6HWWLQJV button at the top of the screen will access the
Stakeout Settings.
/ !! : These buttons are used to select the section
of the road that you want to stake.
;
Offset from the segment above ___ : When checked, is
the offset distance that will be applied to the selected
design point. A positive offset extends from the design point away
from the centerline. A negative offset extends towards the centerline.
X-Slope (%) : is the slope of the selected road section.
1/2 Road Width : displays the width of the selected road section
defined in the previous screen. This value can quickly be edited from
this field.
HR : is the rod height.
%DFNVLJKW« : accesses the Backsight Setup screen (Page R-78).