Spectra Precision Survey Pro v3.80 Recon iPAQ Reference Manual - Manual (Page 123)

Stakeout Menu
R-117
Stake List of Points Screen
6WDNHRXW 6WDNH /LVW RI 3RLQWV
The Stake List of Points screen is used to stake points from a
specified list of points. Points can also be selected by description or
polyline.
6HWWLQJV : located at the top of the screen, accesses the
Stakeout Settings screen (Page R-35).
7DS 3RLQWV« : displays a map of the current job.
Simply tap the points that you want to stake and then
tap OK.
7R)URP« : opens a window where a range of points
can be defined. The points within the specified range
can then be staked.
: Allows you to select points using a variety of other
methods including: select all points; all control points;
all non-control points; by description; or by polyline.
Design Point : displays the point to be staked. The
initial Design Point is the first point of the selected
polyline or point range.
&KDQJH 'HVLJQ 3RLQW« : opens the Edit Point List screen where the
current point list can be edited.
Increment : is the number of points to advance from the Design Point
after tapping 1H[W 3RLQW ! . (A negative integer can be entered to
have point numbers advance in descending order.)
Height of Rod : is the length of the rod.
1H[W 3RLQW ! : Advances the Design Point by the Increment and
automatically solves to open the Stake List of Points screen where
you can begin staking the point. The points are advanced in the same
order that they were defined when the polyline was created or when
the point range was defined.
%DFNVLJKW« : accesses the Backsight Setup screen (Page R-78).