Spectra Precision Survey Pro v3.80 Recon iPAQ Reference Manual - Manual (Page 148)

Survey Pro Reference Manual
R-142
Stake Spiral and Offset – Screen Two
Station to Stake : is the desired station on the spiral
curve that you want to stake.
Station Interval : is the value that is added to the Station
to Stake after the 1H[W 6WD button is pressed.
1H[W 6WD : advances the
Station to Stake by the Station
Interval .
Offset : is the horizontal distance of the offset from the
spiral curve. The offset occurs on the left (while viewing
the spiral from the
Start Point ) when the L is selected or
on the right when R is selected.
Note: An offset of zero would result in the spiral curve
itself being staked.
9 2IIVHW : will result in the elevations for the design points to be
adjusted by the value entered here and will change the cut / fill
values accordingly. Design elevations will be lower when is selected,
and higher when
U is selected.
*UDGH : specifies a slope from the spiral curve to the curve that is
being staked. When this is a non-zero value, the elevation for the
staked points will increasingly differ from the corresponding design
elevations on the spiral curve as the
Offset value increases.
Height of rod : is the length of the rod.
%DFNVLJKW« : accesses the Backsight Setup screen (Page R-78).
%DFN : returns to the previous screen.
6ROYH! : accesses the third screen, described next.
Note: A motorized total station will automatically turn toward the
design point after pressing
6ROYH! depending on the configuration of
the Stakeout Settings screen (Page R-35).