Spectra Precision Survey Pro v3.80 Recon iPAQ Reference Manual - Manual (Page 57)

Job Menu
R-51
Edit Alignments
The Edit Alignments screen is used to create and edit alignments,
which can then be used with routines such as Offset Staking, Offset
Points, Offset Lines and Road Layout.
Alignments are used to describe all of the horizontal and vertical
details of a road’s centerline. An alignment does not use existing
points to define any particular locations on the alignment, although a
point can be used to anchor the starting location, which is the same
location for both the horizontal and vertical parts of the alignment.
Any location on an alignment where a change occurs is called a node.
An alignment can contain straight sections, grades, horizontal,
vertical, and spiral curves. The horizontal and vertical portions of an
alignment are defined separately and independently, but they are
both combined within the software to create a single alignment with
horizontal and vertical characteristics.
Add / Edit Alignments
-RE (GLW $OLJQPHQWV or 5RDGV (GLW $OLJQPHQWV
The Add / Edit Alignments screen displays a list of all
the existing alignments in the current job. The right
portion of the screen shows a graphic of the horizontal
and vertical portion of the selected alignment.
1HZ« : opens the Edit Alignment screen where a new
alignment can be created from scratch.
(GLW« : opens the Edit Alignment screen where the
details of the selected alignment can be edited.
'HOHWH« : is used to delete the selected alignment.
: The power button accesses the following routines:
•
Create Points : opens the Create Points screen
(Page R-244) where points can be stored that
coincide with the selected alignment.