Spectra Precision Survey Pro v3.80 Recon iPAQ Reference Manual - Manual (Page 126)

Survey Pro Reference Manual
R-120
Stake to Line – Screen Two
The second screen is where the staking is performed. The graphic
display of this screen will change depending on how close the rod is to
the specified line. The initial screen that is displayed before a shot is
performed shows the position of the total station, the line of the
backsight and the specified line to stake. Each type of graphic is
displayed below.
Note: Tap the graphic portion of the screen for an expanded view.
Height of Rod : is the length of the rod.
; Coarse EDM (fast shot) : When checked, sets the total
station to coarse mode for faster, but slightly less precise
measurements.
BACK / FORWARD : is the distance that the rod must
travel BACK (away from the total station) or FORWARD
(toward the total station) in order to occupy the specified
line.
LEFT of Line / RIGHT of Line / ON LINE : is displayed if
the rod is to the left or right side of the line, or is on the
line. The
LEFT and RIGHT side is determined as if
occupying the Start Point and facing the Foresight Point or
Direction of the line, specified in Screen One. ON LINE is
determined if you are within the Horizontal Distance
Tolerance specified in the Stakeout Settings screen (Page R-35).
Offset Dist. : is the perpendicular offset from the specified line to the
rod. This is the minimum distance that the rod must travel to occupy
the line.
Station : is the station on the specified line where the offset occurs,
relative to the Start Point .
Shot Data : displays the information measured by the total station
during the previous shot.
6KRW : takes a shot to the prism.