Yokogawa Value Series FX1000 - Manual (Page 142)

4-6
IM 04L21B01-17EN
4.2 Output Format of Text Data
The following types of text data are available. The format for each type is described
in this section. The table below indicates the data types and the corresponding output
commands.
Data Type Corresponding Output Command
Setting data/basic setting data FE0,FE2
Decimal position/unit information FE1
Measured and computed data FD0
Relay status and internal switch status FD6
Communication log FLCOM
FTP client log FLFTPC
Operation error log FLERR
Login log FLLOGIN
Web operation log FLWEB
E-mail log FLEMAIL
SNTP access log FLSNTP
DHCP access log FLDHCP
Modbus communication log FLMODBUS
Alarm summary FLALARM
Message summary FLMSG
Status information IS0,IS1
Ethernet information FAIP
File list MEDIR
Check disk MECHKDSK
Manual sampled/report data information MODIR
Manual sampled/report data size MOSIZE
User information FU0,FU1
Note
The “CRLF” used in this section denotes carriage return line feed.
Setting Data/Basic Setting Data
• The FE command is used to output the data.
• The setting/basic setting data is output in the order of the listed commands in the table
in section 3.2, “A List of Commands.” However, the setting information for the following
commands is not output.
• Setting commands (setting)
SD/FR command
• Setting commands (control)
All commands from BT to IR
• Basic setting commands
XE, YO, YE, and YC commands
• The output format of the setting/basic setting data conforms to the syntax of each
command.
• Some commands are output in multiple lines. (Example: Commands that are specified
for each channel.)
• Syntax
The two-character command name and the subsequent parameters are output in the
following syntax.
EACRLF
ttsss···sCRLF
··············
ENCRLF
tt Command name (SR, SA···, XA, XI···)
sss···s Setting/basic setting data (variable length, one line)