Yokogawa Value Series FX1000 - Manual (Page 134)

3-52
IM 04L21B01-17EN
3.10 Output Commands (Special
response commands)
*I Outputs instrument information
Syntax *I
Description Upon receiving this command, the FX outputs
the following information about itself as a
comma-separated string of ASCII characters with
a terminator at the end: manufacturer, model,
serial number, and firmware version.
Output example YOKOGAWA,FX1000,99AA0123,F1.01
3.11 Maintenance/Test
Commands (Available when
using the maintenance/test
server function through
Ethernet communications)
close Closes another device’s
connection
Syntax close,p1,p2:p3
p1 Port on the FX (1 to 65535)
p2 PC IP address
(0.0.0.0 to 255.255.255.255)
p3 Port on the PC (0 to 65535)
Example close,34159,192.168.111.24:1054
E0
Description You cannot use this command to disconnect a
server port. You also cannot use this command
to disconnect from the instrument that you are
operating. Use the quit command instead.
con Outputs connection information
Syntax con
Example
con
EA
11/06/09 12:34:56
Active connections
Proto Local Address Foreign Address State
TCP 192.168.111. 24:34261 192.168.111. 24:1053 ESTABLISHED
TCP 0. 0. 0. 0:80 0. 0. 0. 0:
0 LISTEN
TCP 0. 0. 0. 0:34261 0. 0. 0. 0: 0 LISTEN
TCP 0. 0. 0. 0:34260 0. 0. 0. 0: 0 LISTEN
EN
TCP
Protocol used
Local Address
FX socket address
Displays “IP address:port number”
Foreign Address
Destination socket address
Displays “IP address:port number”
State
Connection state
ESTABLISHED
Connection established
3.10 Output Commands (Special response commands)/3.11 Maintenance/Test Commands