Ent4, Soah, Hour – Watlow Series 982 User Manual
Page 97: Ent3, Program menu
WATLOW Series 982 User’s Manual
7.3
Programming, Chapter 7
Program Menu
[Ent4]
Event 4:
Selects whether Event 4 is on or off.
Range:
On or OFF
Default:
OFF
Hidden if: Hardware not present or Ot4 = AL4, AL4n or no
[SoAH]
Soak: The following parameters are associated with the soak step.
[Hour]
Hour:
The number of hours plus the Min and SEC parameters equal the
total step time at temperature under the SoAH step type.
Range:
0 to 99
Default:
0
[Min]
Minutes:
The number of minutes plus the Hour and SEC parameters
equal the total step time at temperature under the SoAH step type.
Range:
0 to 59
Default:
0
[`SEC]
Seconds:
The number of seconds plus the Hour and Min parameters
equal the total step time at temperature under the SoAH step type.
Range:
0 to 59
Default:
0
[Ent3]
Event 3:
Selects whether Event 3 is on or off. Only appears if Ot3 =
Ent3.
Range:
On or OFF
Default:
OFF
Hidden if: Hardware not present or Ot3 = AL3, AL3n or no
[Ent4]
Event 4:
Selects whether Event 4 is on or off. Only appears if Ot4 =
Ent4.
Range:
On or OFF
Default:
OFF
Hidden if: Hardware not present or Ot4 = AL4, AL4n or no
[`WE]
Waitfor Event Input:
The program will wait at this step until the desired
status of the event is satisfied. Selecting dSbL disables this feature. See
Chapter 7.
Range:
dSbL, On or Off
Default:
dSbL
Hidden if: Ei1 and Ei2 not equal to WE
[WPr]
Waitfor process crossover value:
The program will wait at this step
until the desired process value is reached. If gSd is greater than zero the
closest edge of the guaranteed soak band is the process crossover value.
Selecting dSbl disables this feature. If time also entered, countdown will
not begin until WPr has been satisfied. See Chapter 7.
Range:
dSbl, rL1 to rH1
Default:
dSbL