Watlow Series 982 - Manual (Page 36)

4.10 WATLOW Series 982 User’s Manual Setup Menus, Chapter 4
Setup-Input
Calibration Offset 2
Offset the input 2 signal by a positive or negative value. This allows
you to compensate for lead resistance, sensor errors or other factors.
[CAL2] This prompt appears only on controllers with [`In2] (Input Menu)
set to [SLiD].
If Default
↓ ↓
[``°F [-999] … [```0] … [`999]
[`C_F] [CAL2] [CAL2] [CAL2]
(Global Menu)
[``°F] & [`r†d] [-9(9] … [[``)0] … [`9(9]
[`C_F] [`In1] [CAL2] [CAL2] [CAL2]
(Global Menu) (Input Menu)
[``°C] [-555] … [[```0] … [`555]
[`C_F] [CAL2] [CAL2] [CAL2]
(Global Menu)
[``°C] & [`r†d] [-5%5] … [[``)0] … [`5%5]
[`C_F] [`In1] [CAL2] [CAL2] [CAL2]
(Global Menu) (Input Menu)
[-999] … [```0] … [`999]
units
a process input [CAL2] [CAL2] [CAL2]
is selected
Hunt
Set the deadband, as a percentage of output, to keep the valve from
hunting.
• The slidewire hysteresis [SHYS] setting provides additional control over a
valve.
[Hunt] This prompt appears only on controllers with [`In2] (Input Menu)
set to [SLiD].
Default
↓
[``)1] … [``!0] … [10)0]
[Hunt] [Hunt] [Hunt]
[CAL2]
˜
NOTE:
See Chapter 9 for
more information
on slidewire feed-
back.
[Hunt]