Retransmit low limit, Retransmit high limit, Arl] [`arh – Watlow Series 982 User Manual
Page 52: Setup-output
4.26
WATLOW Series 982 User’s Manual
Setup Menus, Chapter 4
Setup-Output
Retransmit Low Limit
Select the low limit for the retransmit signal at output 3.
• The default value is equal to [`rL1] or [`rL2] (in the Input Menu)
depending on whether [Aout] is set to [Prc1] or [Prc2].
[`ArL] This prompt appears only on controllers equipped with retransmit
hardware (98__-____-M___ or 98__-____-N___) and with [Aout] not set to
[``no].
[-999] … [`ArH]
[`ArL]
[`ArL]
Retransmit High Limit
Select the high limit for the retransmit signal at output 3.
• The default value is equal to [`rH1] or [`rH2] (in the Input Menu)
depending on whether [Aout] is set to [Prc1] or [Prc2].
[`ArH] This prompt appears only on controllers equipped with retransmit
hardware (98__-____-M___ or 98__-____-N___) and with [Aout] not set to
[``no].
[`ArL] … [9999]
[`ArH]
[`ArH]
[`ArL]
[`ArH]
˜
NOTE:
See Chapter 9 for
more information
on retransmit.