Watlow Series 982 - Manual (Page 95)

How to Program and Run the Series 982
In this chapter, we define each parameter of the Program Menu. A
description of a few Series 982 features follows, along with a sample pro-
file to experiment with programming the Series 982. You will quickly
grasp the necessary terms and concepts by programming and running
your profiles. Enter your profile values in the Master Step Chart at the
end of the chapter.
Program Menu
Create your ramp and soak profiles here in the Program menu. You have
the choice of up to four profiles with up to six steps each. Each step can
be programmed for one of five step types. Choose one step type per step.
Program Prompts
Entering the program menu: Push the Mode key until the OPEr prompt
appears. Use the Up or Down key to select Prog in the upper display.
Press the Mode key to enter the Program menu.
[File]
File: Represents the profile to be edited or viewed.
Range: 1 to 4
Default: 1
[StEP]
Step: Represents the current step of the profile to be edited or viewed.
Range: 1 to 6
Default: 1 then automatic increment
WATLOW Series 982 User’s Manual 7.1 Programming, Chapter 7
(Set point step)
Set point step
Hour
Minute
Second
Rate in unit/minute
Event 3 Status
Event 4 Status
(StPt)
SP ( )
Hour ( )
Min ( )
Sec ( )
rAtE ( )
Ent3 ( )
Ent4 ( )
(Soak step)
Hour
Minute
Second
Waitfor event input
Waitfor process value
Event 3 Status
Event 4 Status
(SoAH)
Hour ( )
Min ( )
Sec ( )
WE ( )
WPr ( )
Ent3 ( )
Ent4 ( )
(Jump-loop step)
Jumpstart
Jumpcount
(JL)
JS ( )
JC ( )
(Link file step)
File to link to
(LFIL)
LFIL ( )
(End step)
Select end type
(End)
End ( )
File (# to program)
Step (# to program)
Step type
File ( )
StEP ( )
StyP ( )
(Prog)
OPEr
JF ( ) Jumpfile
Figure 7.1 -
The Program Menu.
Chapter 7 The Run Menu