Watlow Series 982 - Manual (Page 44)

[`Ot3]
4.18 WATLOW Series 982 User’s Manual Setup Menus, Chapter 4
Setup-Output
Silencing 2
Select silencing to inhibit alarm 2 on startup and to allow the opera-
tor to reset the alarm output, not the visual display.
• Silencing disables the alarm until the signal is between [A2LO] and
[A2HI].
[`AL2] This prompt appears only on controllers equipped with output 2
hardware (not 98__-___A-____) and with [`Ot2] set to [`AL2] or [AL2n].
Default
↓
[`OFF] [``On]
[SIL2] [SIL2]
Output 3
Set the way that output 3 will respond to a difference between the
set point and an input variable.
• [`AL3] de-energizes output 3 in an alarm condition.
• [AL3n] energizes output 3 in an alarm condition.
• [Ent3] sets output 3 to an event output.
[`Ot3] This prompt appears only on controllers equipped with output 3
hardware for a relay (98__-____-B___, 98__-____-J___ or 98__-____-K___) or
switched dc (98__-____-C___).
Default
↓
[`AL3] [AL3n] [Ent3] [``no]
[`Ot3] [`Ot3] [`Ot3] [`Ot3]
˜
NOTE:
See Chapter 8 for
more information
on alarms.
˜
NOTE:
See Chapter 8 for
more information
on alarms.
[SIL2]