Watlow Series 982 - Manual (Page 66)

4.40 WATLOW Series 982 User’s Manual Setup Menus, Chapter 4
Setup-Comm
Protocol Type
Select the communications protocol.
• [FULL] selects ANSI X3.28 2.2 - A.3.
• [``on] selects Xon/Xoff.
• [Mod] selects Modbus.
[Prot] This prompt appears only on controllers equipped with communi-
cations hardware
(98__-____-_R__ or 98__-____-_S__ or 98__-____-_U__ ).
Default
↓
[FULL] [``On} [Mod]
[Prot] [Prot] [Prot]
Address
Select an address for the controller. The computer will use this address
when communicating with this controller.
[Addr] This prompt appears only on controllers equipped with communica-
tions hardware for EIA/TIA-485 and EIA/TIA-422 (98__-____-_S__).
If Default
↓ ↓
[`485] [```0] … [``31]
[IntF[ [Addr] [Addr]
[`422] [```0] … [```9]
[Intf] [Addr] [Addr]
[Prot]
[Addr]