Watlow Series 982 - Manual (Page 32)

4.6 WATLOW Series 982 User’s Manual Setup Menus, Chapter 4
Setup-Input
˜
NOTE:
These values do not
affect the low or the
high set point limit
for process alarms.
[`rL1]
[`rH1]
Range Low 1 and
Range High 1
continued from
previous page.
[``°F] [``°C]
[`rL1] [`rH1] [`rL1] [`rH1]
[```r] {``32]…[3200] [```0]…[1760] 98__-2__-___ only
[`in1]
[```S] [``32]…[3200] [```0]…[1760]
[```b] [``32]…[3300] [```0]…[1816]
[`rtd] [-328]…[1472] [-200]…[`800]
[`r†d] [-9(9]…[99(9] [-7#3]…[53&7]
[4-20] [-999]…[`999] units
[0-20] [-999]…[`999] units
[`0-5] [-999]…[`999] units
[`1-5] [-999]…[`999] units
[0-10] [-999]…[`999] units
Calibration Offset 1
Offset the input 1 signal by a positive or negative value. This allows you
to compensate for lead resistance, sensor errors or other factors.
[CAL1] This prompt always appears.
If Default
↓ ↓
[``°F [-999] … [```0] … [`999]
[`C_F] [CAL1] [CAL1] [CAL1]
(Global Menu)
[``°F] & [`r†d] [-9(9] … [[``)0] … [`9(9]
[`C_F] [`In1] [CAL1] [CAL1] [CAL1]
(Global Menu) (Input Menu)
[``°C] [-555] … [[```0] … [`555]
[`C_F] [CAL1] [CAL1] [CAL1]
(Global Menu)
[``°C] & [`r†d] [-5%5] … [[``)0] … [`5%5]
[`C_F] [`In1] [CAL1] [CAL1] [CAL1]
(Global Menu) (Input Menu)
[-999] … [```0] … [`999] units
a process input [CAL1] [CAL1] [CAL1]
is selected
[CAL1]