Watlow Series 982 - Manual (Page 62)

4.36 WATLOW Series 982 User’s Manual Setup Menus, Chapter 4
Setup-Global
Idle Set Point
Select the set point that will take effect after a power interruption.
[IdSP] This prompt only appears if [Pout] is set to [IdSP].
If Default
↓ ↓
[``°F] [`rL1] … [``75] … [`rH1]
[`C_F] [IdSP] [IdSP] [IdSP]
(Global Menu)
[``°C] [[`rL1] … [``25] … [`rH1]
[`C_F] [IdSP] [IdSP] [IdSP]
(Global Menu)
[`rL1] … [``75] … [`rH1] units
a process input [IdSP] [IdSP] [IdSP]
is selected
Profile Start
Select whether the profile starts at the current set point value [StPt]
or the current process value [Proc].
• If [Pout] is set to [Cont] and [PStr] is set to [Proc], then if power is
interrupted the controller will use the current process value as its set
point.
[PStr] This prompt always appears.
Default
↓
[StPt] [Proc]
[PStr] [PStr]
[PStr]
[IdSp]
˜
NOTE:
Decimal points may
not always be in the
position specified
depending on the
the settings in the
Decimal 1 [dEC1]
parameter in the
Input Menu.