Reaching the diagnostics, 2 diagnostics menu and prompts, Factory-diagnostics – Watlow Series 982 User Manual
Page 88: Diagnostics menu, Reaching the diagnostics menu, Diag
→
[diAg]
Diagnostics Menu
↑
µ
[FctY] Factory Menus
↓
?
µ
[dAtE] Factory Ship Date (page 6.3)
↓
?
µ
[SOFt] Software Revision
↓
[Sn--]
µ
[----] Serial Number
↓
?
µ
[AMb] Ambient Temperature
↓
?
µ
[Acnt] Ambient A/D Count
↓
?
µ
[`gnd] Ground A/D Count
↓
?
µ
[cnt1] Input 1 A/D Count (page 6.4)
↓
?
µ
[cnt2] Input 2 A/D Count
↓
?
µ
[itY1] Input 1 Module
↓
?
µ
[itY2] Input 2 Module
↓
?
µ
[OtY1] Output 1 Module (page 6.5)
↓
?
µ
[Oty2] Output 2 Module
↓
?
µ
[Oty3] Output 3 Module
↓
?
µ
[Oty4] Output 4 Module
↓
?
µ
[dISP] Test Displays
↑
↓
?
←
µ
[tout] Test Outputs
6.2
WATLOW Series 982 User’s Manual
Factory Menus, Chapter 6
Figure 6.2 -
The Diagnostics
Menu.
Factory-Diagnostics
❸ Select the Diagnostics Menu
[diag], then press the Mode key µ
to step through the prompts.
❹ Press the Up-arrow key > or the
Down-arrow key < to select one of
the prompt values.
In the Diagnostics Menu only the val-
ues of [dISP] and [tout] can be
changed.
TL
W
WA
PROCESS
L1
L2
L3
L4
DEV
% OUT
DISPLAY
SERIES 982
MODE
HOLD
RUN
Reaching the Diagnostics
Menu
[``no] [`YES]
[dISP] [dISP]
[`OFF] [out1]
…
[out4]
[tout] [tout]
[tout]
Enter your settings,
from the controller’s
upper display.