Watlow Series 982 - Manual (Page 69)

TL W WA
PROCESS
L1 L2 L3 L4
DEV
% OUT
DISPLAY
SERIES 982
MODE
HOLD
RUN
WATLOW Series 982 User’s Manual 5.1 Operation Menus, Chapter 5
Navigating the Operation Menus
To reach the Operation Menus, begin in the Display Loop and press the
Mode key µ. The Operation Menu prompt [OPEr] will appear in the
lower display. The three Operation Menus are: System [`SYS] , PID
[`Pid] and Program [Prog]. Use the Up-arrow > or Down-arrow <
key to select a menu and the Mode key µ to step through a menu.
You will not see every prompt in any of these menus. The unit’s configura-
tion and model number determine which prompts appear. After stepping
through each menu, the Series 982 returns to the Operation Menu prompt
[OPEr]. Use the Up-arrow > and Down-arrow < keys to select the next
menu, or use the Mode key µ to advance through the same menu again.
To move backwards through the menu hold the Mode key µ down and
press the Up-arrow key >. Use the Up-arrow > or Down-arrow <
key to change the prompt setting.
Chapter 5 The Operation Menus
Figure 5.1 -
Navigating the
Operation Menus.
System
Menu
p. 5.2
PID
Menu
p. 5.10
Program
Menu
p. 7.1
❶ Begin in the Display Loop, and press the Mode key
µ to reach the Operation menus [OPEr].
❷ Press the Up-arrow > key to select one of the
Operation menus.
TL W WA
PROCESS
L1 L2 L3 L4
DEV
% OUT DISPLAY
SERIES 982
MODE
HOLD
RUN
˜
NOTE:
Press the Display
key ∂ to return to
the Display Loop
from any point in
any menu.