Watlow Series 982 - Manual (Page 87)

TL W WA
PROCESS
L1 L2 L3 L4
DEV
% OUT DISPLAY
SERIES 982
MODE
HOLD
RUN
WATLOW Series 982 User’s Manual 6.1 Factory Menus, Chapter 6
Navigating the Factory Menus
To reach the Factory Menus, begin in the Display Loop and press the Up-
arrow > and Down-arrow < keys together and hold for three seconds.
The [`SEt] prompt will appear in the lower display. Press and hold the
Up-arrow > and Down-arrow < keys together again for three seconds
until the [Fcty] prompt appears in the lower display. The Factory Menus
will not appear if the hardware lockout DIP is set to on. (See Chapter 1 for
more information on DIP switch settings.) The two Factory Menus are
Diagnostics [diAg] and Calibration [`CAL]. Upon reaching the Factory
Menu prompt [Fcty] use the Up-arrow > or Down-arrow < key to
select a menu and the Mode key µ to step through a menu.
You will not see every prompt in any of these menus. The unit’s configura-
tion and model number determine which prompts appear. After stepping
through each menu, the Series 982 returns to the Factory Menu prompt
[Fcty]. Use the Up-arrow > and Down-arrow < keys to select the next
menu, or use the Mode key µ to advance through the same menu again.
To move backwards through the menu hold down the Mode key µ and
press the Up-arrow key >. Use the Up-arrow > or Down-arrow <
key to change the prompt setting.
Chapter 6 The Factory Menus
Figure 6.1 -
Navigating the
Factory Menus.
[diAg] [`CAL]
[Fcty] [Fcty]
❶ Press the Up-arrow > and Down-arrow < keys
together and hold until the [`SEt] prompt appears in
the lower display. Press and hold again until the
[Fcty] prompt appears in the lower display.
❷ Use the Up-arrow key > to select one of the
Factory Menus.
TL W WA
PROCESS
L1 L2 L3 L4
DEV
% OUT DISPLAY
SERIES 982
MODE
HOLD
RUN
NOTE:
Press the Display
key ∂ to return to
the Display Loop
from any point in
any menu.
˜
NOTE:
The Factory Menus
can only be entered
when the setup
prompt [`SEt] is
displayed.
Diagnostics Calibration
Menu Menu
p. 6.2 p. 6.7
ç
CAUTION:
When navigating
thru the Factory
Menus, outputs will
be disabled.
˜
NOTE:
The Factory Menus
will not appear if the
hardware lockout
DIP is set to on.
See Chapter 1 for
more information.