Watlow Series 982 - Manual (Page 83)

WATLOW Series 982 User’s Manual 5.15 Operation Menus, Chapter 5
Operation-PID
Output 2 Reset
Tune the control action to eliminate the offset or droop between the
set point and the actual process value for PID A output 2.
When set
to [`)00], reset is disabled.
[`rE2] This prompt appears only if [`dFL] (Calibration Menu) is set to
[``US] and [`Pb2] is set higher than [```0]. When set to [`)00], reset is
disabled.
Default
↓
[`)00] … [`(99] repeats/min .
[`rE2] [`rE2]
Output 2 Integral
Tune the control action to eliminate the offset or droop between the
set point and the actual process value for PID output 2.
When set to
[`)00], integral is disabled.
[`It2] This prompt appears only if [`dFL] (Calibration Menu) is set to
[``SI] and [`Pb2] is set higher than [```0].
Default
↓
[`)00] … [9(99] min./repeat
[`It2] [`It2]
[`rE2]
[`It2]