Watlow Series 982 - Manual (Page 7)

WATLOW Series 982 User’s Manual 1.3
DIP Switches
Starting Out with the Watlow Series 982, Chapter 1
DIP Switch Locations and Functions
The Series 982 has several Dual In-line Package (DIP) Switches inside the
control. Depending on your model number, your unit can have as few as
one DIP switch or as many as five DIP switches. Use the rest of this chap-
ter as a DIP switch reference guide.
To set any DIP switch:
1. Remove the control chassis from the case. Release the two tabs on one
side of the bezel, by pressing in firmly on each until you hear the tab
snap. Release the two tabs on the opposite side of the control. You
may need to rock the bezel back and forth several times to release the
chassis.
2. Use the following graphics in the rest of the chapter to locate and identify
each DIP switch and the desired settings.
TL TL W WA
PROCESS
L1 L2 L3 L4
DEV
% OUT
DISPLAY
SERIES 988
MODE
HOLD
RUN
Release
Tabs
Release
Tabs
Figure 1.3 -
Press the release
tabs to remove the
controller chassis.
TL TL W WA
PROCESS
L1 L2 L3 L4
DEV
% OUT
MODE
SERIES 989
DSPY
HOLD
RUN
Release
Tabs
Release
Tabs