Watlow Series 982 - Manual (Page 64)

4.38 WATLOW Series 982 User’s Manual Setup Menus, Chapter 4
Setup-Comm
˜
NOTE:
The Communications Menu appears only
on controllers equipped with communica-
tions hardware (98__-____-_R__ or
98__-____-_S__ or 98__-____-_U__ ).
See Data Communications with the Series
988 Family of Controllers for detailed
information on communications.
❸ Press the Mode key µ to step
through the prompts.
❹ Press the Up-arrow key > or
the Down-arrow key < to select
one of the prompt values.
Input
Menu
p. 4.2
Output
Menu
p. 4.12
Global
Menu
p. 4.28
Communications
Menu
p. 4.38
❶ Begin in the Display Loop, and
press the Up-arrow > and Down-
arrow < keys simultaneously for
three seconds to reach the Setup
Menus.
❷ Press the Up-arrow key > to
select one of the Setup Menus.
…
…
…
Reaching the Communications Menu
Figure 4.38 -
Navigating the
Communications Menu.
→ [COM]
Communications Menu
↑
µ
[`SEt] Setup Menus
↓ ?
µ
[bAUd] Baud Rate (page 4.39)
↓ ?
µ
[dAtA] Data Bits and Parity
↓ ?
µ
[Prot] Protocol Type
↓ ?
µ
[Addr] *Address
↑ ↓
?
←
µ [IntF] *Interface Type
*Prompts may not appear, depending on
controller configuration.