Teledyne LeCroy ArbStudio - Manual (Page 98)

ArbStudio
90 922244-00 Rev A
Limits Settings
The frequency interval for the Intermediate Segment is described by
Frequency Inf [Hz] and Bandwidth [Hz].

The upper frequency for the Intermediate Segment is Frequency Inf
+ Bandwidth.

Frequency Inf must be set to a multiple of the Bandwidth value.

The 256 samples constituting the segment can be edited as a
standard segment, by editing its components.
The Profile Settings section is similar to the Segment Manager section
described in Advanced Waveform Editing (on page 61). With respect to the
Segment Manager case the component frequency can be provided only in
terms of Cycles, while the component amplitude must vary between -1 and
1.
The constant value amplitudes for the lateral interval are set by means of
the Amplitude Inf and Amplitude Sup indicators for the Low Frequency
constant value and the High Frequency constant value intervals,
respectively.
Profile Command
The following buttons are used for editing the Component List.

Add Component Adds a component to the list. This component can
be set for addition (or subtraction, multiplication, or division) with
others components in the list. An error message is shown when the
Component List exceeds the amplitude range.

Remove Component Removes a component from the Component
List.

Remove All Components Removes all components from the
Component List.