Teledyne LeCroy ArbStudio - Manual (Page 16)

ArbStudio
8 922244-00 Rev A
Back Panel
Numbered callouts on this image correspond with the following
descriptions.
1. POWER - The power switch.
2. DC IN - 12 V – 2.5 A DC connector.
3. USB - USB 2.0 connector.
4. EXPANSION BUS - The Expansion bus connector is located on the
rear panel of the ArbStudio 1104 and 1104D models only. Using the
appropriate expansion cable, up to 8 total 4 Channel ArbStudio units
may be connected.
It is possible to have a system with up to 8 independent arbitrary
waveform generators, each with the ability to have a synchronized
trigger.
PLEASE NOTE THE FOLLOWING:

ArbStudio 1104 and 1104D units sharing the Expansion bus
must all be connected to the same controller (PC) via USB or
hub.

If more than one ArbStudio 1104 or 1104D are connected to
the same PC, they must also be linked through the Expansion
bus.
Making Expansion Bus Connections
In order to connect several ArbStudio 1104 or 1104D units you must first:

Connect the ArbStudio units using the Expansion bus.

Connect all ArbStudio units to a single PC by using an USB connector
or by using a HUB.

Ensure all ArbStudio units are correctly recognized by the operating
system.