Teledyne LeCroy ArbStudio - Manual (Page 174)

ArbStudio
166 922244-00 Rev A
Creating a Phase Modulated Waveform
Create a Phase Modulated Waveform by first creating a workspace with
Arbitrary Waveform Generator as the Operating Mode and at least one
DDS Channel. See steps 2, 5, and 6 in Arbitrary Waveform Generator Setup
Example (on page 27) for details (and be sure to select DDS instead of
Arbitrary during step 2). If you already have a workspace open, be sure it
meets the aforementioned requirements before proceeding with the
following steps:
1. Double-click the Carrier Editor under Channel 1 (DDS) on the Device
Control Tree. (Channel 1 can be any DDS channel you have
configured under Arbitrary Waveform Generator operating mode in
your workspace.)
2. The default Component 1 Carrier settings are shown on the
Component Definition dialog. These default settings include a Sine
wave Type with a Length of 2048 samples, Amplitude of 1 V, and 1
Cycle. You can modify Component 1 of the Carrier as desired.
3. Double-click Modulation Editor under Channel 1 (DDS) on the
Device Control Tree. (Channel 1 can be any DDS channel you have