Teledyne LeCroy ArbStudio - Manual (Page 178)

ArbStudio
170 922244-00 Rev A
6. Now, press the Run/Stop button on the ARBStudio toolbar.
The software loads the settings and the waveforms into the
ArbStudio 1102/1104 instrument and starts generating the
waveforms.
7. The Phase Modulated Waveform1 is generated on the CH1 BNC
output. You can connect an oscilloscope to this output and analyze
the signal.
8. Stop generating waveforms by pressing the Run/Stop button again
or the Force Stop button (also on the ARBStudio toolbar).