Teledyne LeCroy ArbStudio - Manual (Page 32)

ArbStudio
24 922244-00 Rev A
PLEASE NOTE THE FOLLOWING:

Before performing any of the scenarios, you must first make sure
you've correctly powered on your instrument, connected to your
PC, and launched the ArbStudio software as explained in the
Getting Started with ArbStudio (on page 10) section.

Some more specific steps are required around Creating a New
Workspace for each scenario. Details are provided for those
scenarios when necessary.
With the aforementioned prerequisites completed, you can perform the
following scenarios:
1. Creating Your First Analog Waveform (on page 147)
2. Creating a Sequence of Waveforms (on page 151)
3. Creating an Amplitude Modulated Waveform (on page 155)
4. Creating a Frequency Modulated Waveform (on page 161)
5. Creating a Phase Modulated Waveform (on page 166)
6. Importing a Waveform from an Oscilloscope (on page 171)
7. Creating Digital Waveforms (on page 175)
Creating a New Workspace
1. From the Start Page, click the New Workspace button.
The New Workspace form is shown and displays the connected
ArbStudio hardware on the Instrument selection section.
2. Enter a Name and Description for your new Workspace.
3. Click the Browse button to locate your workspace file, select it and
click the OK button.
The Setup Devices wizard is shown.