Teledyne LeCroy ArbStudio User Manual
Page 28
ArbStudio
20
922244-00 Rev A
Save Workspace - saves newly-created or edited
workspaces.
System Setup - selects the Master/Slave channel when
multiple devices are connected by the expansion bus or
when you want channels managed by an event.
Device Setup - accesses more detailed ArbStudio option
settings.
RUN/STOP - first loads setting parameters and the
waveforms into the instrument, and then it
starts/stops the waveform generation for all enabled
channels selected from the Channels Selection
button.
Ch(1, 2, 3, 4) - selects Channel
- You can use this
Pod x - activates or deactivates the RUN/STOP
command for the specified Pod. This control is only
available when the Digital Pattern option is enabled.
Force Trigger - makes the instrument generate
an internal trigger signal and forces a start
event on the selected channels/pods.
Force Stop - forces a stop event on the selected
channels/pods.
3. Editing Area - This main display area shows the waveforms selected
from the Project Waveform List or Sequencer Window. You can also
create/edit waveforms and load the Sequencer from this location.
4. Device Control Tree - The Device Control (navigation) tree provides
access to channel settings and tools to edit standard/modulating
waveforms, set the amplitude profile of the modulated signal, and
load the sequencer.