Teledyne LeCroy ArbStudio - Manual (Page 15)

Operator’s Manual
922244-00 Rev A 7
B
Hardware Inputs and Outputs
Front Panel
Figure 3-1. ArbStudio 1104 model with a POD B connector and two additional
Channel Outputs. Although digital pods appear on all models, they are only
active on 1102D and 1104D models.
DIGITAL POD A / DIGITAL POD B
1. DIGITAL POD A / DIGITAL POD B Probe connectors
NOTE: DIGITAL POD B is only available on ArbStudio 1104. POD A
and POD B are only active on 1102D and 1104D models. ArbStudio
1102 and 1104 can be upgraded to include the digital pattern
generator.
2. EXT CLK BNC input connector for external clock
3. TRIGGER

Trigger Out - BNC output connector for Trigger OUT.

Trigger In - BNC input connector for Trigger IN.
4. ANALOG OUTPUTS 12 V to 12 V BNC output connector
NOTE: Ch3 and Ch4 are only available on ArbStudio 1104 and 1104D
models.
5. STATUS LED Indicates instrument power status
6. POWER-ON LED Indicates the power status of the instrument. The
status led can be OFF, ON, or Blinking denoting the following
conditions:

OFF. The instrument is ON and connected to a PC, but drivers
have not been installed.

ON. The instrument is ON, connected to a PC, and correctly
configured.

Blinking. ArbStudio 1102/1104 is uploading firmware for
channels.