Teledyne LeCroy ArbStudio - Manual (Page 50)

ArbStudio
42 922244-00 Rev A
Channel Settings - Trigger OUT Tab
This section allows setting the Trigger OUT parameters.
Trigger out source
Allows selecting the possible trigger source which generates a Trigger Out
event.
One or more sources can be chosen at the same time.
The signals that can be sent to the Trigger OUT output include Start, Stop,
and Event.
NOTE: Pod A Trigger IN and BNC Trigger IN are available on even channels
only.
P
OLARITY
You can choose the Trigger OUT signal polarity as Positive or Negative.
D
ESTINATION
A logic combination of the Trigger Out event of the enabled channels is
always available on the dedicated BNC Connector and on Pod A / Pod B
Trigger Out signal on the instrument front panel see Setup Device Trigger
Out Math section.